Adjusting Automatic Keystone

Automatic keystone makes image adjustment effortless. However, the automatic keystone doesn’t work in all situations e.g. projecting in an angle or to an uneven surface. You can disable the automatic keystone and adjust the image manually.

Video instructions here.

Adjusting Automatic Keystone Offset

If the automatic adjustment is not adequate, you can adjust the offset.

Artome X12

1. Long press FREEZE button on the remote for 2 seconds. The freeze button starts blinking.
2. Adjust the keystone offset by using the direction buttons. Reset the adjustment with OK button.
3. The offset follows when the projectors physical angle is moved.
4. Exit the image adjustment mode by pressing FREEZE or wait for the mode to timeout.
   
   

Artome X10

1. Long press FREEZE button on the remote for 2 seconds. The freeze button starts blinking.
2. Adjust the keystone offset by using the direction buttons. Reset the adjustment with OK button.
3. The offset is reset when the projector’s physical angle is moved.
4. Exit the image adjustment mode by pressing FREEZE or wait for the mode to timeout.
   
   

Disable Automatic Keystone and Adjust Manually

If you want to adjust the image manually, the automatic keystone needs to be disabled.

Artome X12

With Artome Connect

1. Connect to your Artome with the Connect app
2. Navigate to Settings tab > Device > Auto keytone: OFF
3. Use the projector menu or Artome Remote to adjust the image manually.
   
   

With Artome Remote

1. Long press FREEZE button on the remote for 2 seconds. The freeze button starts blinking.
2. Long press OK button for 5 seconds to toggle auto keystone on or off
   1. AV MUTE button blinks to indicate auto keystone is disabled
   2. VOL + button blinks to indicate auto keystone is enabled
3. Adjust the keystone manually by using the four direction buttons.
4. Exit the image adjustment mode by pressing FREEZE or wait for the mode to timeout.

Artome X10

With Artome Remote

1. Long press FREEZE button on the remote for 2 seconds. The freeze button starts blinking.
2. Long press OK button for 5 seconds to toggle auto keystone on or off
   1. AV MUTE button blinks to indicate auto keystone is disabled
   2. VOL + button blinks to indicate auto keystone is enabled
3. Use the up and down buttons to adjust keystone. Use the side buttons to adjust focus.
4. Exit the image adjustment mode by pressing FREEZE or wait for the mode to timeout.
   
   

From Projector Menu

1. Disable the auto keystone. Navigate to Menu > Position > Realtime Keystone: OFF
2. Adjust the image manually. Navigate to  Menu > Position > Screen Adjustment: Keystone

This feature was introduced in a firmware release. Updating device firmware